introduction and inquiry

Home › Forums › Contemporary Daguerreotypy › introduction and inquiry

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 26, 2010 at 7:28 pm #10320
    TheDagLab
    Participant

    I use http://www.onlinemetals.com/

    No problems so far and they will cut to size… for a little extra cost.

    Fast too.

    May 26, 2010 at 11:05 pm #10322
    rivera1212
    Participant

    Dagwood,

    thanks for the reply, i found Eric before i came to the forum as well as Binh Danh out of San Jose ca, but neither one was will to instruct. i used to do etching on copper and i was buying my copper from Takach press out of NM. nice guys to work with! then i started buy from these guys in Monterey were i live.

    METAL SPECIALTIES

    METAL SPECIALTIES. 554 Del Monte Avenue P. O. Box 2473. Monterey, CA 93940. PHONE: (831) 375-0375 FAX: (831) 375-3382. e-mail: metspec@pacbell.net …

    http://www.metalspecialties.net

    May 26, 2010 at 11:07 pm #10324
    rivera1212
    Participant

    i forgot to tell you their copper was a little rough but it did come with a protected layer of mylar to protect the surface as best they could, but it will still need to be polished out

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Return to the Top